Do you like the Manto range by Rincoe? In this article, we’ll be covering the latest member of this range – Manto Pro. Just buy from the vapesourcing online vape store if you like it. Here we go!
Rincoe Manto Pro Kit features a PC body with rounded edges, which makes it very light and comfortable to hold in the hand. Powered by dual 18650 batteries, the Manto Pro Mod can fire up to 228W in VW mode and also supports BYPASS mode and TC mode (Ni/Ti/SS/TCR). When the batteries are low, you can either take them out to charge or just charge them up via a micro USB port on the control face.
The control face is located on the side of the mod, above the USB port, there are two adjustment buttons, a monochrome OLED screen, and a square fire button. With them, you can operate and monitor the device effortlessly. For safety, Manto Pro also comes with a range of safety features, including over charging protection, 10s cut-off protection, short circuit protection, low voltage protection. Paired with the Manto Pro Mod is a Metis RDA, I think you guys should be very familiar with it, so we don’t go into details again here. The whole kit only sells for $29.99, just give it a shot!
You may also like: smok g priv 3 near me
Parameters as below
Manto Pro Mod
Size: 93mm * 52mm * 26.5mm
Battery: dual 18650 batteries(not included)
Modes: VW/TC(Ni200/Ti/SS)/Bypass modes
Power range: 1-228W
Input voltage: 6.0-8.4V
Resistance range of atomizers: Wattage(VW/BYPASS): 0.08-5.0ohm;
Temperature Control Range: 200-600ºF(100-315°C)
Drip tip: 810POM drip tip